Programming Your FAR-9 MOSFET for 3 Round Burst!
- Posted on
- By AEX News
In this quick tech tip, Airsoft Extreme walks you through how to safely and easily program the G&G FAR-9 MOSFET for 3-round burst fire. This guide covers safety steps, programming instructions, how to deactivate burst mode, and tips to get the most out of your new AEG.
Programming the G&G FAR-9 MOSFET: 3-Round Burst Setup Guide
Welcome back to another Airsoft Extreme Quick Tech Tip! Today we'll be discussing how to program your G&G FAR-9 MOSFET for 3-round burst.
Before You Begin: Safety First
First, remove your magazine and ensure your hop-up and barrel are completely free of BBs. This step is extremely important—if you don’t clear the gun first, you may discharge a BB inadvertently during programming.
How to Program the G&G FAR-9 for 3-Round Burst
Once your AEG is clear, plug your battery into the gun. After the battery is connected, follow the steps below to set your MOSFET to 3-round burst mode:
- Set the gun to Semi-Auto.
- Pull and hold the trigger for 10 seconds.
If you lose count, don’t worry—the MOSFET will emit an audible tone to indicate the setting has been applied.
- Switch the gun to Full Auto. It should now fire in 3-round burst.
How to Deactivate 3-Round Burst
To return the gun to normal function, simply repeat the exact same steps above.
We hope this Quick Tech Tip helps you enjoy your G&G FAR-9 in a more dynamic and personalized way. Thank you for joining us! We look forward to sharing more helpful information with you in future posts.
