iPower 11.1V 1100mAh 20C LiPo Nunchuck 2x
Get the most performance out of your Electric replica with iPower’s 11.1v LiPo batteries. The higher voltage supercharges your motor to give you a faster and much more responsive gearbox. LiPo batteries offer a significant increase in power and efficiency over NiMH batteries and have become the standard battery type for most of the airsoft community.
AEX recommends installing a MOSFET prior to using 11.1v LiPos on replicas in order to preserve gearbox components.
WARNING: LiPo batteries require a balance charger designed specifically for LiPo batteries. Using a charger not designed for LiPo batteries will create a chemical imbalance in the battery which could result in injury or destruction of property.
Charger sold separately.
- Higher voltage allows for a faster gearbox cycle, rate of fire, and trigger response over lower voltage counterparts
- 1100mAh capacity lasts for ~1000 shots before needing a recharge
- Able to power most intermediate and higher-end electric replicas
- Pre-installed Mini Tamiya connector for maximum compatibility
- Nunchuck design is meant to fit in rear-wired replicas with an AR-style or similar stock
Length x Width: 4 x 0.5in
Discharge Rate: 20C
Connector Type: Mini Tamiya
You may also like
Don’t just charge your battery out in the open. Put it into an iPower small lipo charge bag to make sure your battery is housed in a fire retardant bag just in case something goes wrong.
Designed for M4 Stock Tubes made to hold “Buffer Tube LiPo”, this configuration is shorter than the 1200mAh LiPo so that the stock can be fully collapsed.