iPower Small LiPo Charge Bag
The iPower small charge bag was constructed to house LiPo batteries as the charges to help contain accidents if the casing of the battery is compromised and catches fire. The bag has a fire-resistant material within it to keep the fire from spreading from the housing.
Remember to always check the condition of your Lipo batteries before use and charging
Features:
- Fire retardant material
- A lot of space to carry multiple batteries
- Thick exterior padding
- Velcro closure design
Specifications:
Color: Silver
Size: 11.5 x 9 inch
You may also like
AAP SKY RC E3 Lipo Balance Charger
$22.99
What’s more important than the battery itself? Making sure it’s charged! (And charged properly!)
iPower 11.1v 1450mAh 20C 3X Nunchuck LiPo Battery Tamiya
$23.99
Got all this extra space in your stock? Why not fill it with a battery?
iPower 7.4v 1450mAh 20C 2X Nunchuck LiPo Battery Tamiya
$20.99
Don’t “cell” yourself short on power and pick up this iPower 2x Nunchuck battery!
iPower 11.1v 2200mah 20c LiPo Nunchuck
$32.99
The iPower 11.1v 2200mah LiPo nunchuck battery gives the player the power to increase the trigger response and fire rate in a compact package.
iPower 7.4v 2200mAh 20C 2X Nunchuck LiPo Battery Tamiya
$21.99
iPower 7.4v 2200mah Nunchuck Lipo Battery with Mini-Tamiya connector.
iPower 11.1V 1100mAh 20C LiPo Nunchuck
$21.99
1100mAh capacity lasts for ~1000 shots before needing a recharge
Able to power most intermediate and higher-end electric replicas
Pre-installed Mini Tamiya connector for maximum compatibility
iPower 7.4v 2200mAh 20C 2X Nunchuck LiPo Battery Deans
$23.99
2200mAh capacity lasts for ~2000 shots before needing a recharge
Pre-installed lower resistance Deans connector allowing for a more solid connection between replica and battery both physically and electrically
Valken 7.4v 1300mAh 30C LiPo Nunchuck
$27.99
1300mAh capacity lasts for ~1100 shots before needing a recharge
Able to power almost all replicas
Pre-installed Mini Tamiya connector for maximum compatibility
Nunchuck design is meant to fit in rear-wired replicas with an AR-style or similar stock
